honda elite gy6 swap

Gas doesn’t reach the carburetor for some time while cranking. One of the most important fasteners of the swap is the rear axle nut, which secures your rear wheel to the engine. Reply. A stock Honda Ruckus motor is 2.5 horse power and the GY6 is 7.5 horse power. Now the problem I’m having is the bike has no power like a 150cc should, I thought about changing out the CVT kit, it’s has 11 pole stator. This impacts fuel economy and causes the bike to run rough and erratic at low speeds, often killing the engine when coming to a stop.

There is no replacement for displacement!Life doesn't get any easier with our Honda ruckus GY6 conversion kit. On a more positive note however backfiring that he mentioned and the several tries to get it to turn over lend itself to a thought of ignition timing being over advanced.

The GY6 150 will literally give you 3 times the power. Thanks joeyI also checked the oil and it’s filled to the top. This kit will come with everything (excluding the exhaust system) to convert your Honda ruckus to a GY6 150cc swapIF YOU WANT THIS KIT, BUT DON'T NEED EVERYTHING, SIMPLY CLICK ON EACH PART TO ADD TO CART We’ve talked mostly about the downsides of GY6 swapping, so closing this article with the positive aspects of swapping seems appropriate.We advise against having a local mechanic shop attempt to install your swap. We have been having no spark problems for the past few days. Backfiring itself is often associated more with too lean or advanced ignition timing rather than an excess of fuel. However, we highly recommend using the swap as an opportunity to learn and get yourself familiar with the workings of your swapped Ruckus.We get a lot of calls and direct messages from Ruckus owners that have non-BDX swap kits (sold by other vendors) that are looking here for technical advice. Things like aftermarket mufflers may also repetitively loosen over time if not properly supported. This harness will allow you to use all of your oem controls, wiring harness, fuel pump, and even kill the engine with the kill switch correctly (unlike most harnesses they are reversed). No exhaust system is in this kit.

Contact the maker of your harness and try to get an answer as to what’s going on.The Ruckus service manual specifies an initial oil change after the first 600 miles, and then changing the oil routinely every 2500miles. FREE SHIPPING OVER $150 (We are still shipping parts during this epidemic) Thanks again for the support!

This article isn’t meant to cover installation practices, but is more of a heads-up for hang ups and issues you should expect during and after a GY6 swap into your Ruckus.

I want it to have the same factory look but just with a bigger 150cc motor. We’re happy to lend a hand, but be aware of the following:Thank god I found your website I have a gy6 150cc doing the swap myself of coarse, I was wondering if I should do all the body work and whirring first or ,engine first.Actually the info here has put me off im no mechanic and at that stage in life where i would love just to buy one already with the gremlins sorted out…… god! I took the carb out and there is fuel in it. Rectifier has 3 yellow, one black and one green. The simple answer to this is to upgrade to an 11-pole stator, but this isn’t totally necessary.A side note, if you have severe battery charging issues (while riding), this isn’t normal and there is a fault in the system. ... or gy6 swapped ruckus. Synthetic is not necessary, but should not be used at all until after the break-in period. This could possibly be my problem as far as the fuel going in and out the carb.

I am about to swap my 2009 Honda Ruckus to make it a GY6, but I do not want to stretch it out. If so, that probably explains the hard starting. why didnt honda make a more powerful version of this?. These things I have said for Joey’s benefit, I have no doubt Buggy Depot knows all this and a whole lot more.Good luck. Honda Ruckus / Elite / Dio CNC levers $ 70.99. Is the automatic choke important that it has to be hooked up? They work well to get fuel to the carburetor, too well actually. You also have no indication as yet by the information if the bike actually has compression (or as much as it should have).I am not knocking you, nor picking on Joey, just making the observation that at present the field is still wide open to possibilities with a lot of narrowing down to do with your eyes, ears and senses being that of a person who did not really understand the first thing you asked him to try. I recently get on a pics from a fatty rockus … I totally fall in love … And I wonder … after percuating a ruckus (zoomer in greece ) Can I fit Sh300 engine ? Get the engine running the best it can, and to the point where it is showing symptoms then turn off the engine. Thanks.How to install the BDX Honda Ruckus GY6 Swap HarnessHow to bleed your brakes, without wasting hours of timeGY6 Swapping The Honda Ruckus: What To Expect From Your Swap